For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.

0 Answers  

---

My friend has faced this question! I don't know clearly. So please anyone give me the correct and short answer to this question? What is variable frequency drive? Types, what is star to delta? Why this arrangement necessary?

5 Answers   Asian Paints, TCS,

---

what is working principle of presure and temperature guage?

4 Answers  

---

what is beta ratio?

3 Answers  

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---

in which mode of the zener diode act when load voltage is approximately constant

1 Answers  

---

how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line

0 Answers  

---

What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?

0 Answers   Jubilant,

---

my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card

0 Answers  

---

1. How many output signals do wew have in process control? 2. Could you write down the names of the pre-commissioning and commissioning stage test instruments and explain them (more than 5 items)? 3. What is the first step to commission a transmitter on service? 4. What is RTD? 5. Find the output value in MA of a temperature transmitter (RTD Type) at 120degree celius? 6. What is the O/P signal of a pneumatic transmitter? 7. What is the O/P signal of an elctronic transmitter? 8. What is the close loop and open loon?

4 Answers  

---

what is the procedure to isolate flow a transmitter and flushing it?

8 Answers   Petrofac,

---

If a flow transmitter (magnetic type FT) that can measure flow and temperature, then why in some industries people use flow transmitter and temperature transmitter in the same line 1 after another? Even after 1 single flow FT is capable of measuring flow as well as temperature.

1 Answers   Process Control Technologies,

---