Answer / sudheer

If we connect two NGR at a time , there is a possibility of
producing circulating current. and the generator will tripp
on circulating current fault. so normally we disconnect the
neutral of first generator and then we connect the other
generator neutral with NGR.

Answer / anand

Due to circulating current DG sets will trip.

how to select cable size according to ampere.

1 Answers  

---

How much the fault level of 11 k.v.,22 k.v., 33 k.v. (in Maharashtra- M.S.E.D.C.L) for calculation of short circuit current & selection of h.t.cable.

1 Answers  

---

why CRGO material used in transformer?

2 Answers   Honda, Yazaki,

---

If I have a motor of 1 MW with 6.6 kV, running at 35% load, how can I save energy without reducing the load?

6 Answers   Reddy Labs,

---

What is ferrite affects and what is disadvantage of ferrite affects.

1 Answers  

---

what are the losses of capacitor??

1 Answers  

---

how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.

0 Answers   Hindustan Unilever Limited,

---

AC voltage only create magnetic flux in coils, but in Solenoid coil how 24V DC volt create flux and pick the plunger

5 Answers  

---

How can transformer winding insulation be measured (Delta & Star Connections)?

3 Answers  

---

Difference between single phase and three phase?

1 Answers  

---

how does calculate loss correction factor in transformer

1 Answers  

---

in a dc shunt motor what happens if motor takes high current,no speed

2 Answers  

---