Whats the frequency used in Rodents Repllant System?????
What is the Diff btw Infrasonic & Ultrasonic Frquencies???



Whats the frequency used in Rodents Repllant System????? What is the Diff btw Infrasonic & Ultr..

Answer / suhana_t

The frequency used in Rodents Repllant System is
above 20KHz i.e Ultra Sonic Frequency..

Infrasonic:-The Frequencies bellow 20 Hz.

Ultrasonic Frquencies:-The Frequencies Above 20 KHz.

Audio Frquencies:-The Frequencies ranges btw 20 Hz to 20
KHz.

Is This Answer Correct ?    3 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

is that any software calculator to calculate the size of cable

0 Answers   JSW,


11KV electrical line going through the forest in cloudy night ,how can we find the direction of line.

5 Answers   Bhel, Cesco, HZL, Nesco,


What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.

1 Answers  


What happen when change order of CT in GIS feeder?

0 Answers  


redundant connection in contactor?

0 Answers   Emerson,






why they charge more bill for low power factor rather than high power factor

2 Answers  


Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.

0 Answers  


i have one source transformer with the capacity of 50KVA, connected with two loads 10kw and second one is 15kw.. how can i calculate first load in KVA and second one in KVA .. because Kva rating, power factor rating of of transformer is different from the load… there must be some way to calculate load KVA rating and power factor….

1 Answers  


When we give supply to a transformer 11 kv and we get 415v from it, so when we give supply to same transformer 415v on ht side what we get? and When we gives supply to any transformer to L.T. side 415v or 220v What supply is on H.T. side?

2 Answers   Ashoka Electricals,


how to calculate units consumption for a 12 hp motor /hr.

0 Answers  


Pl. brief about break-down maintenance of machine tool.

0 Answers  


formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)