7- What is the Dissipation Factor and the difference
between it and Insulation Resistance Test?
8- What is the task (function) of DC and AC reactors in
power plant?
9- What is the task (function) of (open delta with
earthed) in some types in transformers?
10- What is the base of the selection of the vector group
in transformers?
11- What is the zig-zag transformer and its function by
drawing in large detail?
12- What is the polarity ?
13- Why we make short between phase(R) in high side and
phase (r) in low side in vector group test?
Where High Side ( R ,S and T ) and Low Side (
r ,s and t ).
14- What are the time on delay and time off delay?
15- What is the vector group?
15- What is the task (function) of different types of
vector group such as Dyn11 , Dd0 , YNd1,……..,?
No Answer is Posted For this Question
Be the First to Post Answer
Why at the starting of induction motor current is high?
The unit of quantity of electricity is the:(a) volt(b) coulomb(c) ohm(d) joule
what is a breaker fail relay
What is notching in dc machine?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Which factor decide the colour of the light emitted from a Led?
Which one is more accurate servo or stepper motor and why?
We have three phase dg of 12kva rating.If the load of each phase is not constant.That means one phase drowning more load than remaining two phase..Then what will happen to dg?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
Relation in between KWH & KVAH for Electrical consumption unit & how we can relate if KWH is lower than KVAH
11 Answers Deepak Fertilisers, Torrent Pharma,
can we use inductor in case of d.c.,if yes then what will happen in circuit