A bearing is designated as 6205 , what is it’s bore
Answers were Sorted based on User's Feedback
Answer / vijayendra
Generally for bearing bore diameter is 5 times the last
number in its designation i.e. for designation 6205, Bore
diameter should be 25 (5 times last no.5)
|Is This Answer Correct ?||78 Yes||5 No|
Answer / balachandran
yup.....its is correct
|Is This Answer Correct ?||34 Yes||7 No|
Answer / sameer sane
The last two digits when multiplied by 5 give the bore dia
where as the first two digits give the type of bearing ; eg
taper roller or angular contact bearing etc
|Is This Answer Correct ?||26 Yes||0 No|
Answer / rohit tiwari
Its a simple foam just multiply the last digit with 5 of
any bearing number for e.g if the number is 22210 then the
bore will be 10x5= 50.same will be 6205 ,5x5=25.
|Is This Answer Correct ?||24 Yes||2 No|
Answer / vinoj k
Last two digit of the basic designation is multiplied by 5
will give bore diameter in mm.
|Is This Answer Correct ?||15 Yes||0 No|
Answer / kumar
whatabout other numbers?
|Is This Answer Correct ?||12 Yes||1 No|
Answer / abhi
as every one is interested in perfect cncept rather than a
soln to this ans..
00,01,02,03 in the last 2 digits of bearing number indicates
10,12,15,17 mm bore dia respectively and from
04,05.....,96(last 2 digits of bearing num) the bore dia is
the two digits multiplied by 5
eg 05-- 5*5=25mm, 96---96*5=480, and after that ie, aftr
480mm they are indicated by '/', eg 500mm dia to represent
in bearing num is /500
|Is This Answer Correct ?||12 Yes||3 No|
Answer / bhaskar
6 is the bearing type: Deep groove ball bearing
2:series : light series
5*5:25 is the bore diameter
|Is This Answer Correct ?||9 Yes||1 No|
Answer / gokulkumar
answer is correct..then wat is the need of other three
|Is This Answer Correct ?||3 Yes||0 No|
Answer / ishti
ok so dear how we know the type of bearing
|Is This Answer Correct ?||2 Yes||0 No|
Which is the welding process you have carried out in workshop?
wt is dynamic coupling????
Define flash in mould making ?
Is there any metal that does not contain iron?
Do you receive good benefits as an engineer job?
Which reactor requires no moderator ?
Steam turbine (function an parts)
What are the performance expectations of this position over the first 12 months?
Suppose a steel bar of cross sectional area A is subjected to load P at one end and 2P at the other end ,what will be the induced stress in the bar?
what is the difference between BSP therad and BSW thread?
What is wrap-around?
What is booster in pneumatic ?