Answer / sharif shaik

Vector Group Depends on the type of windings in Primary & Secondary of Transformer.
Let take one transformer example
Primary Winding is "Delta" (D)
Secondary Winding is " Star" (S)
Phase angle between two transformers is lag 30 degrees

Therefore : Vector group = DSn11

Where n= Neutral
11 = For 30 Degrees constant value

what is the value of voltage & current lightning during rainy season.

0 Answers  

---

What are the effects of electrical faults?

0 Answers  

---

SSC JE ELECT.

1 Answers   CPWD, SSC,

---

What is the accepted limit to increase the choosen transformer capacity over the load and why ?

2 Answers   Asec,

---

What will be cross section area of copper conductor for carry 2000 amps & 2500 amps....sq.mm.?/

3 Answers  

---

what is the advantage of pwm pulse compare to squarewave pulse.

2 Answers  

---

What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?

0 Answers  

---

in 50 mw generator if field is open in full load running condition what happen and for protection which relay used?

5 Answers   century,

---

I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.

0 Answers  

---

What is the tolerence limit between neutral and earth in 230 V AC System?

7 Answers   NTPC,

---

why grid failure happens?

1 Answers  

---

What is load boxes ?

0 Answers   AMIE, PEPL,

---