Answer / jigs

normally for higher capacity of powerplant the gen voltage
is 11kv than it is step up to 132/220 KV depending on the
capacity of the powerplant and than it is transfered to the
primary distribution system.from there the power is
distributed to all the customers buy the secondary
distribution system.

Why do you use an isolator on both sides of the circuit breaker? ( shortly answer)

2 Answers  

---

What are series and parallel isolators?

3 Answers  

---

what is a circuit breaker. Weite the types of circuit breaker.

4 Answers  

---

bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.

1 Answers  

---

why auto transformer connected in star?

1 Answers  

---

sir, plz tell me how much kvar capacitor required for 1000 amp or 500 Kw load ? what is the formula ?

14 Answers   CSPL,

---

What is the function of the auto reclosure relay?

1 Answers  

---

why chock were used in old tubelights but are not newest tubelights?

0 Answers  

---

can i know how to design overcurrent setting and earth fault for 11kv & o.433kv system assuming tx 1000kva.

2 Answers  

---

What are the basic elements used for modeling mechanical translational system?

0 Answers  

---

When both contractor star & delta is hold in star delta motor ?? So what happen in this case ??

1 Answers  

---

A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3

0 Answers  

---