Answer / nhpc

The strength of concrete is defined as per the IS code
456:2000 and not by IS 800:2007.
Strength depends on the grade of the concrete i.e. higher
the grade higher the strength.From M10 to M20 are defined
as ordinary concrete, from M25 to M55 are defined as
standard concrete and from M60 to M80 are defined as high
strength concrete.
In most of the reinforced concrete,M25/A40 is taken.The
high performance concrete(HPC) consists of M50/A20.

Answer / manu s

As per 1s 456 2000 M80 which is classified under high
strength concrete wil have max strength.
This will be having wide range of admixtures and will use
specially made cement.the case of petronas towers is an example.

Answer / rajeevan

IS 800 is for design using structural steel. Hence the
answer to the question is "grade of concrete is not
specified in IS 800, which is a steel design code".

Answer / dhivya

M80

Answer / g.janakiraman

M80 used in mumbai

Answer / dharmendra

AS PER IS:456(2000) MIX ABOVE M-60 ARE TREATED AS HIGH
STRENGTH CONCERET

Answer / mohan raj

m30

As per Method of measurement how to calculate no of column stirrups (ie: upto slab bottom or beam bottom)

1 Answers  

in one hour , one 200 excavator , how much quantity (mcube)can load ? soil is not hard not soft

1 Answers   GKC Projects Limited GKCPL,

What are the ingredients of pre-stressed concrete?

1 Answers  

how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?

1 Answers  

what is the difference between rise and tread? what is its standered size? what is waist slab?what is the standered length of staire-case? also what is the angle between floor and landing?

5 Answers  

minor loss due to sudden contraction 1>flow contraction 2>Expanssion of flow after sudden contraction 3>cavitation 4>boundry friction

1 Answers  

how to calculate water cement ratio?

6 Answers   IVRCL, Saroj Group, Sobha Developers,

GIVE US YOUR FULL DETAIL OF THE FOLLOWING… FULL NAME.. PERMENENT MAILING ADDRESS DIRECT CONTACT NO E MAIL ADDRES.

1 Answers  

Would you cause a 55-gallon drum of water to weigh more by climbing in?

1 Answers  

Why alternate bars are given bent-up in slab and how to decide the length of bent up?

5 Answers  

size of the traditional brick is 248*121*71 in mm,but why the size are like this.why the size are not like that 211*154*75 in mm

1 Answers   Merlion,

How to calculate numbers of carpenter, fitter, mason, unskilled worker on the basis of built up area or floor plat area of building?

2 Answers   L&T,