what is ASCR cable and where we use it?
Answers were Sorted based on User's Feedback
Answer / abdul wajid
First of all it is not ASCR but ACSR it is used in
Transmission and Distribution Over Head Lines
| Is This Answer Correct ? | 10 Yes | 0 No |
Answer / abdul wajid
It is not ASCR but ACSR alluminium conductor steel
reinforced used in Transmission and Distribution Over Head
Lines
| Is This Answer Correct ? | 10 Yes | 1 No |
alluminium steel andreinforced conductior this is used in
transmission and distrubution.
| Is This Answer Correct ? | 4 Yes | 2 No |
Answer / sunil guru
ASCR is --aluminum conductor steel reinforced --- these
conductor is used at H.V and EHV transmission....
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / minal
This is a steel reinforced & aluminium cored conductor in a
cable. This cable is used for transmission of electrical
energy.
| Is This Answer Correct ? | 2 Yes | 1 No |
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
0 Answers Enmas, Michelin, Reliance,
Differentiate between voltage and current feedback in amplifiers?
What is the role of power pack in substation protection system?
what is V0/V rating of cable
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
operating Lt & HT voltages used in India?
What is the need of black rock stones under the transformer yard?
5 Answers TNEB Tamil Nadu Electricity Board,
is high voltage or high current is danger
When measuring the Insulation resistance of a motor winding (winding to earth) using a megger meter, Applied voltage(1000V) was automatically reduced to 500V. and the measured insulation resistance values are also very low (in Kohm range) Can anyone give me a reason???
What are n circles?
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)