Answer Posted / abdul wajid
It is not ASCR but ACSR alluminium conductor steel
reinforced used in Transmission and Distribution Over Head
Lines
Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
Define average demand?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What are the essential characteristics of signal flow graphs?
What is transmittance?
What are the two major types of control system?
Why is negative feedback invariably preferred in closed loop system?
Where should the lighting arrestor be placed in distribution lines?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
what is the formula for computing cable tray size & capacity
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value