Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / haseeb
ACSR means Aluminium conductor steel reinforced, this
conductor is used in transmission & distribution
| Is This Answer Correct ? | 21 Yes | 2 No |
Post New Answer View All Answers
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
how does a shunt reactor maintains the bus voltage???
operation of protection relay watchdog contact?
What is bridge rectifier and explain with details
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
what is the transiant condition in alternator? and how it can be prevanted?
How to calculate Ith (I thermal) for curent transformer
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
pls,send the previous year written test questions.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
what is meant by tranformer impedance?
