Why not LED burn after showing alarm,as Alarm volt is 11-
13,But LED is of3 volt,why it isnt Burn??






Why not LED burn after showing alarm,as Alarm volt is 11- 13,But LED is of3 volt,why it isnt Burn??..

Answer / pillay

You are right but the voltage to the LED is reduced by
connecting a resistor in series or a few LED are connected
in series so the voltage across each LED IS about the rated
voltage.

Is This Answer Correct ?    5 Yes 0 No

Post New Answer




More Electrical Engineering Interview Questions

What is the minimum distance between MV busbare (P to P & P to E) as per some standards

1 Answers   ABB, Sejong,


what is softstarter? explain briefly where it is used?

2 Answers   Essar,


Control wiring of a dol starter for forward and backward

0 Answers   Basj Industries,


explain me how a power factor is improved by adding a capacitor?what capacitor do to improve it?in simple words and in detail?thx

7 Answers  


List out the the types of Mounting Light fixture?

0 Answers   HLL,






what is the stear deltaprinceple?

0 Answers  


while doing the excitation current test on power transformer what is the value of voltage to be applied? Nomonal rated voltage or 10% of rated voltage? Is it necessary to apply on high voltage side?

1 Answers   ACC,


what are the advantage and dis-advantage of 3 phase 4 wire energy meter?

0 Answers  


what is difrent between earthing and ground

4 Answers  


what is the principle of vvvf drive motor

3 Answers  


Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.

0 Answers  


what is impedence (Z) of transformer, what indicate in transformer , which perameter indicate in transformer

5 Answers   CTS, Suzlon,






Categories
  • Civil Engineering Interview Questions Civil Engineering (4652)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3710)
  • Electrical Engineering Interview Questions Electrical Engineering (15820)
  • Electronics Communications Interview Questions Electronics Communications (2685)
  • Chemical Engineering Interview Questions Chemical Engineering (763)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (127)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (199)
  • Instrumentation Interview Questions Instrumentation (2885)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (74)
  • Marine Engineering Interview Questions Marine Engineering (103)
  • Power Plant Engineering Interview Questions Power Plant Engineering (170)
  • Engineering AllOther Interview Questions Engineering AllOther (1371)