Answer / felixraj

older practice of using shunt for ammeter connection but now
a days dc clamp meters of more then 10000 A are available

Answer / ramniveth

no other way other than putting meter in series

Answer / s muthu kumar

Put ammeter in series connection to the Incommer.

Answer / sennapparajan

if u want to check current use tong tester. or else put
ammeter in series. thats it.

Answer / naresh

use moving coil meter in series with the line

If UG power cable both ends are to be earthed or what? If not why?

0 Answers  

If the neutral wire go pass through the core balance current transformer? If yes then why? and no then why?

2 Answers  

State kirchoff voltage law?

0 Answers  

what is interpose? where it is used and why it is used?

0 Answers  

i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.

0 Answers  

Why capacitor bank does not require in DG Set?

21 Answers   IBM,

why we use primary delta connectin in hight voltage transformer

2 Answers  

which is the best institute for PLC,SCADA,DCS in hyderabad

0 Answers  

what is the formula for hv test for cable and circuit breaker..????

0 Answers  

how terminal voltage increases when load is capacitive (leading pf load)? (explain practically what is happening, not using phasor diagram

1 Answers  

how to select correct size of power cable for inverter duty motor

0 Answers  

Using 11000V/433V,3 ph,50Hz,500 KVA, what is the maximum capacity of motor in KW that can be connected and started at a single moment? Also explain about any calculations and formulas used in deriving the same.

4 Answers