what is priming pump?why it is used ?
Answers were Sorted based on User's Feedback
Answer / sushil
Is A Primiry Pump Use On 500 KVA Above Diesel Generater
Starting Before serculate On Engine Oil
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / shri..
Priming pump is used for resecularating the engione oil.
Shriram
| Is This Answer Correct ? | 1 Yes | 4 No |
why transformer is rated in KVA ?
What is working principal of V.C.B., O.C.B., A.C.B & Over load relay?
in a dc shunt motor what happens if motor takes high current,no speed
direction of tarbine& genrator
why the oscillator doent need the ac voltage??how can it produce the ac voltage by applying the dc voltage only??
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why NGR is required for 11Kv geneartor in power plant
where we use the SFU & FSU?
application s to shunt coil
how will be the capacitance generated in a earthed wire???
what collector is used for 100kmph-120kmph tracion application?
what is the differance of acb and mcb and mccb
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)