Answer / mrudang

if oil has low dielectric strength , ur transformer is in
warning condition ,

why ?? because of in transformer , there is high voltage
winding , it create high temperature , oil is dielectric
medium of two windings , if dielectric strength is low
that means ur oil has moisture content , and it is also
affect the paper insulation of transformer winding

so dielectric strength is very important

Answer / loboreliance2003

dielectric strength of transformer oil should be above 30KV
for 1 min. testing of the transformer oil sample should be
done properly. Ensure no oil bubbles are formed and wait
for bubbles to settle before taking the test.

Why we use stones in switchyard?

3 Answers   Havells, L&T,

---

what is isochronous mod? what is voltage drop mode and p.f mode?

0 Answers   ABB,

---

how to calculate 3 phase clearance in Tower line , 33& 11 KV Line and LT Line.

1 Answers  

---

What is meant by stator? What is meant by rotor?

0 Answers  

---

what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group

0 Answers   Bosch,

---

What is the Efficiency in Electric motor ?

2 Answers  

---

WHY THAT THREE COLORS CHOOSEN IN 3 PHASE? WHAT IS MEAN BY RYB?

2 Answers  

---

54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?

0 Answers   Bajaj, TCS,

---

Why electricity is generated and transmitted at the values of multiples of 11?

3 Answers  

---

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers  

---

what is difference between inductive and reactiveload?

5 Answers   ONGC,

---

FOR ELECTRICAL TRANSMISSION TOWER WHAT SHOULD BE THE MINIMUM HEIGHT FROM THE GROUND? AND WHAT SHOULD BE THE DISTANCE BETWEEN THE TWO CONDUCTOR?

1 Answers  

---