on what basis the partial factor of safety are decided?

No Answer is Posted For this Question
Be the First to Post Answer

More Civil Engineering Interview Questions

1.Fe500 and Fe550 having more yield strength than Fe415.But why are we prefering Fe415.? 2. d^2/162 formula for knowing the steel wt/m apply all these three? Thanks.

Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M hight 3.75 meter 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks

WHAT IS THE MELTING POINT OF STEEL?

What is the strength of cement?

Can we provide lapping of R/f steel for plinth beam in support portion(At column)?

calculation of quantities of cement and sand in 1cum mortar with 1:6 ratio

HOW TO CALCULATE THE CEMENT & SAND REQUIRED FOR 1SQM BLOCKWORK OF 200MM THICK?

how to calculate cement mortor for wet and dry mix for different ratios

How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.

manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.

how to calculate the loads on slab? what are the steps?

what is piers?

Categories
• Civil Engineering (5062)
• Mechanical Engineering (4327)
• Electrical Engineering (16561)
• Electronics Communications (3564)
• Chemical Engineering (959)
• Aeronautical Engineering (214)
• Bio Engineering (96)
• Metallurgy (361)
• Industrial Engineering (253)
• Instrumentation (2972)
• Automobile Engineering (332)
• Mechatronics Engineering (90)
• Marine Engineering (107)
• Power Plant Engineering (170)
• Textile Engineering (198)
• Production Engineering (0)
• Satellite Systems Engineering (90)
• Engineering AllOther (1376)