Answer / prasant

for dc average value,rms value and maximum value is same,so
the form factor is unity.

Answer / ustad

for dc average value,rms value and maximum value is same,so
the form factor is unity.

Answer / akash kumar

form factor= rms/avg
for DC rms=avg
therefore FF=1

Answer / mukhesh

ther is no form factor in dc f f is ratio of rms value
and avg value
rms only in ac means max value in dc avg value taken

Answer / dhaval

in ac always form factor is 1.414 it is ratio of rms value
and average value buat in dc no rms value then dc form
factor is 0

Answer / sathish

The Form factor of DC is always infinite.

Relative synchronous generator

1 Answers  

Definition of grid?

7 Answers   L&T, Pace Power Systems, Vijai Electricals,

why the rotor is outside in case of ceiling fan?

1 Answers   HCL,

Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?

1 Answers  

Why we use Y-Y connection in power transformer (8-10 MVA, 132 kV to 11 KV)and D-y in distribution transformer (2 MVA, 11 KV to 440 Volts)?

4 Answers  

what is first ground fault & second ground fault. This is used in rotor protection of alternator.

1 Answers  

how to claculate the ups load in KVA pls give the if any fourmoul?

4 Answers  

what is ATS & RING MAIN UNIT in Distribution System?And its Function.

2 Answers  

DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?

1 Answers  

i want to measure voltage difference between neutral and earth so i just simply use voltmeter. my question is that may i use this measure continuosly.or there are some electricity board restrication on that? or it creat some problem on my measuring device..?

2 Answers   NEEC,

How much minimum insulation required between 11kv/3.3kv transformer windings?

0 Answers   Descon,

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers   Siemens,