How will you convert a 6 Normal solution to 8 Normal
solution?
- 17 Answers
- 37621 Views
- Reddy Labs, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
If it is 1N of solid check the weight. Assume x grams in 1000 ml. For converting to 3N add remaining weight of solid material. Dissolve thoroughly.
Ex: 1N sodium hydroxide is 40 grams in 1000 ml. If asked three normal, add another 80 grams so that total would be 40 * 3 to get 3N . Similarly from 6 to 8
| Is This Answer Correct ? | 1 Yes | 3 No |
Answer / sudhakar
we can't convert lower normal solution to higher normal
solution.
generally we are using dilution law for preparation of
required normality. N1V1=N2V2
| Is This Answer Correct ? | 4 Yes | 7 No |
Answer / ulab
dilutionlaw N1V1=N2V2, generally dilution means high
concentration to lower concentration by adding solvent.
So question is irrelivent to tell answer and volume of
required solution not mentioned.
So it is better to ask a question like this
How will you convert a 8 Normal solution to 6 Normal
solution of 100mL volume?
Sanissainu
| Is This Answer Correct ? | 1 Yes | 4 No |
Answer / vasudev shetti
Take one third of the 6N solution and evaporate the solvent
completely. Add the residue to the remaining solution (i.e.
two third part of 6N). Your 8N solution is ready
| Is This Answer Correct ? | 3 Yes | 9 No |
WHAT IS PVT TEST IN DISSOLUTION TEST , WHAT IS PVT SIGNIFICANCE AND HOW IT IS PERFORMED ?
in loss on drying Why follows on constant weight not more than 0.5 mg, any region
Explain in detail what are the procedure and calculations involved for accuracy (%Recovery)in method validation?
what is the need of calulation of RRF of impurity in HPLC analysis?
why ph is between 0 to 14
6 Answers Apotex, Reliance, Zydus Cadila,
How to start the dissolution development for unknown tab?
Why we are use 0.005M Sulphuric acid, in control of absorbance performance test UV Spectrophotometer calibration
what is difference between IR & FTIR ? how we calibarte both ? I want to know the procedure.
what is polarity and how to calculate
Why we are having specification 100% above in case of assay as there is only 100% of compound?
2 Answers MSN Pharma, Nectar Lifesciences,
how you confirm the assay method?
why base line not start from zoro in GC Chromatograme.
Organic Chemistry 
