Why pH range is 1-14 nt more than 14???3 5009
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
my interviewer asked me what technical specification you used how to answer that question
what is daily routine of you/mother/father/sister/bro.
reversing of each word in the string
what is mission in weblogic
how to estimate material requirement for an area of house in square feet?
How do i automate a website www.flyashx.com without having any test cases witin a week time.
Any one who apply for Ferro Scrap Nigam Limited cn join with me at email@example.com or 09669717028
Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
how to check regenerative load in drived motor
at which depth the construction of tunnel is economical from cost and engineering aspect.
Tell me about your experience in informatica? what is best mark you can give yourself? How to answer this question?
a table has 2 classifications 1)liabilities 2)earnings this liabitity has 2 elements with 2 input values and the earnings have 2 elements with 2 input values i wrote a query so that my input is liability savings amount1 amount2 xxxx null xxxxxx 0 xxx1 null xxxxx1 0 null yyyy 0 yyyy null yyy1 0 yyy1 my problem is --when i developed a report(d2k) with this data my o/p is liabilities,amount1,savings,amount2 xxxx xxxxxx xxx1 xxxxx1 yyyy yyyy yyy1 yyy1 how could i move this savings,savings values 2 palces up. can any body provide me witha better solution
__ no of controls in form.