Answer / rohith

modem means MOdulator ,DEModulator....
it does tat only.. it converts the digital signals from ur digital device(comp) to analog signals which ll be transmitted over pstn..
n the reverse process on the other side ie. demodulation...



-RO-

Answer / vignesh1988i

MODEM is a input device device which is used to MODULATE & DEMODULATE the given signals into the corresponding opposite signals.

since this modem will be conected to PC or LAP and other end of it will be connected to the wires from outside. so this modem converts DIGITAL to ANALOG signals and vice versa. correspondingly. this much only wat i know


thank u

Answer / venkat

Basically we use digital signals in computer. But we use analog type of communication through wires .So our digital signal needs to be converted into analog signals. This is achieved through the usage of modem . Modem stands for MOdulator DEModulator . Its acts as a modulator thereby converting our digital signals into analog signals.These analog signals can be sent through phone line. In the receiving end the analog signals are again converted into digital signals.

Digital signals have two states { logic 0 and logic 1 }

comment am i wrong or rite .. :D ....

Answer / guru

moderm means modulating and de modulating device

Answer / guest

MODULATION AND DEMODULATION

why we are using the bridge rectifier in most of the circuits instead of full wave rectifier even though the output of both are same?

0 Answers  

What are LAPD and LAPDm?

2 Answers   Qualcomm,

what is virtual grounding?

0 Answers  

What is the main drawback of a single phase half bridge inverter?

0 Answers  

Explain what is pulse logic system?

0 Answers  

If the address bus id 20bits.then the memory space is ?

0 Answers   Verifone,

Hi, i have to appear in L n T managment trainee interview ..please suggest some questions if u have faced similar interviews..!!!

0 Answers   L&T,

i am preparing for aai atc ? plz can u send me som emodel qus?

0 Answers   AAI Airports Authority Of India,

What is the difference allen bradley and siemens plc

0 Answers  

why clock frequency of microcontroller 8051 is chosen as 11.0592 MHZ?

5 Answers   Prolific,

The change in a semi-conductor strain gauge, in resistance on application of strain is mainly due to the change in its

0 Answers   C DAC, CDAC,

sir, please send HPCL INFORMATION SYSTEMS OFFICER SYLLABUS WITH PREVIOUS QUESTION PAPERS

0 Answers