Answer / balamurugan

wide range of speed control is available because we can
vary the firing angle from 0 to 180 degree

Answer / naveen

Most economical operation when cost cosideration, accurate
operation will possible

Answer / arockia doss

Advantages :

1. Fast Switching Characterestics than Mosfet, BJT, IGBT

2. Low cost

3. Higher Accuract.

Answer / tarequl islam mukul

It can set a trigger voltage,then the output current and voltage varies and the desired dc current can be achieved for motor.

Answer / gagan gumar gupta

we can easyly change firing angle of thyristor from 0-180
it is also economical.its speed control is so fast than any
other thing.

Answer / rehan

the main advantage is that ........ we can switch on and
off the device nd vary the waveform in accordace 2 the
firing angle with the same ckt

what is the difference betwteen overcurrent and short circuit fault?

3 Answers  

1. When do you use a VFD motor? 2. If the ceiling fan is on slow speed, does it consume less electricity? 3. If we want the fan to consume less electricity at low speed, what do we have to do? 4. What does “battery of 180 AMP HOUR” mean to you? 5. What does “battery of 180 AMP HOUR” mean to you? 6. If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?

6 Answers   Asian Power, Bhel, Focus, Focus Energy, L&T,

Why power factor does not occur in DG set ?

6 Answers  

what is rated speed?

4 Answers   Actavis,

what mean by analog ,digital,numerical meters and relays? say the example?

0 Answers   ABB,

How to calculate meter constant @ HT yard

5 Answers   Juniper Networks,

What is the difference between Zero Current Transformer and Core Balance CT ?

1 Answers  

1.Whats the use of GNAC(Generator Neutral Accessory Compartment) 2. why generator or any other system require Neutral Grounding and not Phase grounding 3. what happens if any one of the phase is grounded. 4. if 15kv is grounded directly what will happen, why it should not be grounded like that 5. use of of NGTR(Neutral Grounding Transformer and Resistor) for grounding is helpfull and how

5 Answers   BEMCO, CSS, Powergear,

what is distribution board?

0 Answers  

Why does the radius of armature is less than the radius of pole shoe?

0 Answers   ABB,

How can we design MEP services for Commercial Building in area about 22 Acres of land?

1 Answers  

what is the basic principle of TV camera?

0 Answers   BZU,