how the harmonics are generated in transforemer?
Answers were Sorted based on User's Feedback
Answer / sathish
harmonics generated by nonlinear loads is presented
| Is This Answer Correct ? | 28 Yes | 3 No |
Answer / krishnaswamy.b
1. During switching 'on' the transformer that causes
magnetising inrush current with the core still in the
magnetising build-up state harmonics occur.
2. Due to non linear loads.
| Is This Answer Correct ? | 7 Yes | 1 No |
this is due to magnetostriction energy . whenever
ferromagnetic material during magnetization changes
therefore it results in a loss and this effect is
called as magnetostriction and this is the reason
for the generation of harmonics
| Is This Answer Correct ? | 5 Yes | 2 No |
Answer / rakesh gupta
when transformer is running with no load.then current flow
in transformer is very high than rated current of
transformer. this current is know as magnetising inrush
current. it is contain different types harmonics i.e dc
component (30% to 40% ) ,secondary harmonic (30% to
70% ),third harmonic
(10% to 30%).
| Is This Answer Correct ? | 3 Yes | 3 No |
Answer / jay mehta
Plant side many Electrical Drives and UPS connected ,so its
genereted harmonics
| Is This Answer Correct ? | 1 Yes | 4 No |
Upto what extend the powerfactor of a supply system can be improved to be cost effective?
what is principle of DC machines?
5 Answers APTransco, NTPC, Wipro,
why Square root 3 used for three phase?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
What is the reason of using bus-bars on the secondary on the LT transformers?
How many sprinklers should be in one pipe line?
specify the inbuilt protections in DG
how we can know which is Lv side and HV side of transformer by just seeing it?
what is ASCR cable and where we use it?
how do you reduce the skin effect
in transmission line 11kv is step up or step down? why?
in three 3.5 core aluminium ug cable. one cable is used for one phase by shrting R,Y and B wires and other 2 cables used for Y and b phases. balace 3 neutral wires are made common and connected to load. suddenly neutral current was more than line current what is the reason behind this?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)