Pls tell me whether we can use EN3A material for shafts of
Permanent magnet alternator.What will be the effect of
magnetic and nonmagnetic material for shafts on magnetic
properties of PM rotor .
- 0 Answers
- 2983 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
low voltage grounding is done by?? 1)solidly gnd 2)ressistance 3)reactance
what is the resistance value of earthing pit and why they are connected?
what is Ith current?
IAM GOING TO ERECT THE STREET LIGHT.,, I NEED HOW TO CALCULATE LUX., ILLUMINATION.,AND ALL
why using 3 phase
if we want to convert the two 12 V DC batteries in parallel for UPS ? what would be the result ? which is better for a UPS , connect two batteries in series or connect them in parallel ?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
what is joule?
what is the use of ballast in tube
why ground cannot be used as neutral as ground also provides close path for current flowing ?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
Why field rheostat is kept in minimum position?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
