Answer / Rohit Prasad

Connecting three-phase supply lines to the output terminals of a three-phase auto transformer through a 10A fuse and MCB may cause an overcurrent situation, which can damage the transformer. However, if the protective devices operate correctly, they will disconnect the power before significant damage occurs. The transformer should not be permanently destroyed under normal circumstances, but it may require inspection and repair after such an incident.

how can check the resistance of battery contact?

1 Answers   Cipla,

---

In all electric motors, fans are provided to dissipate heat. How it dissipate the heat? By absorbing atmospheric air or by exhausting the heated air generated while running?

2 Answers   Ford,

---

What is AVR in Generators and How is it working.

4 Answers  

---

what are the compensations considered while designing a transmmision line.

1 Answers  

---

IN WHICH MODE THE TRANSFORMER WILL GET A MAXIMUM OUT PUT VOLTAGE. ASKED FOR POWER GRID EXAMINATION STAT-STAR,STAR-DELTA,DELTA-STAR,DELTA-DELTA

3 Answers  

---

Can anybody tell me what the breakdown voltage is for air and what it is for transformer oil please?

4 Answers   Pooja Cables,

---

pls send me some of the solved question booklet of Junior Engineer -2 (ELE) in RRB

1 Answers   RRB,

---

how can the active power and reactive power of an alternator be controlled?

6 Answers  

---

why do we lay up the core of a cable?

1 Answers  

---

WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?

1 Answers   Schneider,

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1 Answers  

---

In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?

3 Answers  

---