WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE
UPS ?

Question Posted / sanjeev jain

3 Answers
9174 Views
Punjab National Bank, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?..

Answer / bijay

OBVIOUSLY OFF LINE UPS IS BETTER THAN ONLINE UPS,WHEN IT
COMES TO POWER SAVING.
REASON BEING IN ONLINE UPS CHARGING(FLOAT CHARGING)IS
ALWAYS CONSUMING ENERGY,EVEN IF THE BATTERY IS FULLY
CHARGED.WHEREAS IN OFFLINE UPS NO NEED OF FLOAT CHARGING IS
THERE,OFFLINE UPS REQUIRES ONLY BOOST CHARGING

Is This Answer Correct ?

14 Yes

1 No

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?..

Answer / rafi

Online ups - When the supply line is on the battery is
charging at the same time we are consuming power from
battery
Offline ups - When the supply line is on the battery is
charging but we are consuming power from the line, when the
line is off then only we are consuming power from battery

Is This Answer Correct ?

10 Yes

1 No

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?..

Answer / srij21

According to me both will draw same power depending upon
the load connecte to it.

Is This Answer Correct ?

1 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values

0 Answers

State kirchoff current law?

0 Answers

ups and invertor battery selection chart and full formula

2 Answers APC,

how to calculate the no. of earth pits required for an electrical installation?

1 Answers Mepax,

What is the Ohms low calculation

2 Answers

400 kvtransmission lines in india are connected in star or delta

10 Answers NTPC,

What type of core material is used for metering C.T and protection C.T???

0 Answers Bhel,

WHY PROTECTION CT IS USED NEXT TO METERING CT?

1 Answers

Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards

0 Answers

CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE IT AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND TAKING OUTPUT FROM PRIMARY?

3 Answers

any earth foult trip the relay but in welding time not trip by earth foult

0 Answers Power Grid, Siemens,

In Star type and Delta type Motors, If one phase will miss/Break then which phase winding will burn and why?

4 Answers

For more Electrical Engineering Interview Questions Click Here