Answer / rajkumar

Pressure angle is an important factor in design of spur
gear.If the pressure angle is high it results in a noisy
operation.
self locking means worm and worm gear gets locked to itself
preventing further power transmission.

What is L 110 spider? What does L &110 indicate

1 Answers   Emmennar Pharma, Mega Limited,

---

what is the ejection system in mould making?

2 Answers  

---

What is the vane diagram in centrifugal pump

2 Answers   Birla Cement, ITC Infotech,

---

What is the sensitive part of the liner

0 Answers   RRB,

---

can any1 provide me the PLACEMENT PAPERS FOR BHEL

0 Answers  

---

Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb

0 Answers   Saudi Ceramics,

---

how does the lybrinth glands work in sealing a turbine? how exactly turbine sealing is done? principle of it?

0 Answers   GMR,

---

RRB JE GR-II OLD QESTION PAPER WITH ANSER

0 Answers   RRB,

---

what is meant by FA(full arc)& PA(partial arc)?

1 Answers  

---

What is the difference between Pipe & TUBE?

6 Answers  

---

why the compression ratio of the diesel should be high?

2 Answers   Castrol,

---

difference between stress and pressure?

3 Answers  

---