if AVR fails in alternator. what will be the effect.
Answers were Sorted based on User's Feedback
GENERATOR WILL FAIL TO START AS THERE WILL NOT BE ANY
EXCITATION TO THE FIELD WINDINGS SO NO EMF WILL BE
GENERATED.
| Is This Answer Correct ? | 2 Yes | 4 No |
Answer / logeswaran
AVR is nothing but a automatic voltage regulator.it ill
regulate the field input based on terminal voltage either no
load or full load condition.
if AVR fails in alternator...?
The alternator output we will get only residual voltage at
no load condition based on the residual magnetism.
The residual Approximately for 1 & 3 phase 4 pole alternators:
min:4 V to max: 90 V.
| Is This Answer Correct ? | 0 Yes | 2 No |
Answer / satya dev ( knight frank)
The function of AVR in the Alternator is to controlled the
Alternator's voltage by controlling the excitation voltage
of stator, if The AVR fails on Load the voltage will be
reduced to zerro.
| Is This Answer Correct ? | 16 Yes | 22 No |
What is the type of electrical earthing recommended in hard rock area
what is the function of starter & choke in the tube light set & how choke give 1000 volts while switching on.
14 Answers ADNOC Abu Dhabi National Oil Company, IBM,
what is the pperating squvance in transmission line for circuit braker, isolater & earthing switch.
In electrical cables what is U and U0 refers?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
HT motors are generally connected in star, what will be the effect if we connect HT motor in Delta?
6 Answers Equate, Ion Exchange,
In ac which gas will be use?
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
what are the affects of loose connection in electrical circuit.
A resistor,inductor and capacitor are connected in series respectively.Voltage across resistor is 40v,across inductor is 70v,across capacitor is 100v.Then what is the total voltage applied across the elements?
What is inrush current?
which one is more costly:single phase induction motor or 3 phase induction motor??give proper reasons..
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)