if AVR fails in alternator. what will be the effect.
Answer Posted / logeswaran
AVR is nothing but a automatic voltage regulator.it ill
regulate the field input based on terminal voltage either no
load or full load condition.
if AVR fails in alternator...?
The alternator output we will get only residual voltage at
no load condition based on the residual magnetism.
The residual Approximately for 1 & 3 phase 4 pole alternators:
min:4 V to max: 90 V.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
What are the causes for the failures of sandwich type (Al) busducts?
How many types are using in 220kv/400 kv swith yard
what is the purpose of silicon dropper used in battery charger?
What are the types of piano switches?
description with working of all parts of a Diesel generator???????
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
how we decide scurt (disc) of insulator with respect to kv rating
what is the basic need of domestic loads 1- voltage 2- current
plz explain the auot-reclosing circuit in electrical engineeing