why ringing is very high in emitter follower and source
follower?
Answers were Sorted based on User's Feedback
Answer / thasneem
because these two ckts can be used for impedance matching...
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / shaf
(ringing is basically a circuit that produces undamped
oscillations).These circuits have the gain of both the
circuits is greater than unity.So they produce undamped
oscillations.
| Is This Answer Correct ? | 2 Yes | 1 No |
For 65hp motors how kvr capacitor should be on??
why rx level is negative in telecom?
Discuss any three advantages that digital systems have over analog
Explain how to measure the insulation resistance for printed circuit boards?
Tell me something about IN call Flow and what is the difference between the flows in both GSM and CDMA technologies?
What are the function of different capacitor, resistors, transister, diods, thyrister( like SCR)in any circuit?
What is the ideal op-amp CMRR ?
What is CMRR? Explain briefly.
5. The determinant of matrix <image> is (a) 1 (b) 9 (c) 15 (d) 21
Hi.im IMRAN.Im pursuing my B.tech final yr.plzzz any 1 guide that vich course shud i take in telecom.either protocol development or protocol testing or hardware plzzzz tell me n hz this important in future n why shud i take.plzzzzz its my request u to send this answer.thnx bro i vil wait for u r answer.k.byeeeeeee
serial to parellel conversion is done by :
What is DTX? Why is it used?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)