What is the cause of major loss in efficiency of an IC
engine?
Answers were Sorted based on User's Feedback
Answer / sriram_veluri
some of the causess for major losses in efficiency are
1.improper compression
2.improper closing and openinig of valves (valve timing)
3.friction between piston and cylinder
| Is This Answer Correct ? | 25 Yes | 7 No |
Answer / shahnawaz
1)incomplete combustion of fule
2)friction between Piston & Clyinder
3)knocking
4)heat in engin
5)without good lubricant
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / radhe shyam
1.friction between piston & waLL
2.improper air fuel ratio
3.back flow of fuel
4.faulty timing of valve system
| Is This Answer Correct ? | 10 Yes | 3 No |
Answer / panni kutti
incomplete combustion also main responsible for loss in
efficiency....
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / sanket
the cause of major loss in efficiency of an IC engine is
heat loss in exhaust gases about 35-40% of total fuel
energy.
| Is This Answer Correct ? | 5 Yes | 0 No |
the energy in an IC engine is produced by the burning of
fuel in each power stroke..inefficiency is created in many
steps..
much of this heat energy is lost with exhaust gas,by
convection,conduction and radiation from the cylinder..only
some of it is converted to useful energy i.e in pushing the
piston down rapidly..this is the major cause of inefficiency
in IC engines.. after ehich various mechanical losses like
friction comes in...
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / ravi
in ic engine heat energy is utilised.& it is low grad
energy.so, its efficiency is less
| Is This Answer Correct ? | 3 Yes | 1 No |
Why would some industries select pneumatics over hydraulic?
Why should we hire you over the others waiting to be interviewed?
How do you calculate cooling energy?
What is enthalpy?
how gearbox ratio was calculated?
what are the main problems of solar electrical systems? to make quality control on, which parameters that need so?
800A bus-coupler system
why we use charcoal layer in aqua silencer to purify the gases??
What do you mean by the term thread size please explain what does 0.125 inch stand for in 0.125 inch npt thread?
what is the composition of cement?
Which is first stress or strain?
how much is the salary for junior works manager?? pls tell me the exact amount.. i mean 15900- 39400.. what does this means?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)