Answer / shivraj gurjar

Solution annealing is a process performed on steels. In our
case, these are primarily the 300 series stainless. The
process consists of heating the material up to a temperature
above 1950°F and holding it long enough for the carbon to go
into solution. After this, the material is quickly cooled to
prevent the carbon from coming out of solution. Solutio-
annealed material is in its most corrosion-resistant and
ductile (farmable) condition.

a three phase squirrel cage induction motor runs slow? list all possible reasons for such fault.

0 Answers  

---

difference between antifriction bearing and journal bearing

9 Answers  

---

A simple problem involing in hoops stress. For sphere: M= [3/2]*p*V*[density of pressure vessel material/Maximum working stress it can tolerate] For Thin walled pressure walls: Hoops stress or stress in the radial direction =p*r/2t ?

0 Answers   Bhel, JPMorgan Chase,

---

what roal of balancing disk in boiler high preesure feed pump.

4 Answers   ABSC, HPCL,

---

difference between machining and non-machining?

0 Answers  

---

What is the spinning jenny?

0 Answers  

---

question related 2 soal car: Working under a bright light bulb or in direct sunlight, experiment with the angle of light hitting the solar panels. What angle gives you the fastest rotation of the wheels? How would you modify this car to make the wheels turn faster? How would you modify this design to make a car that could carry or pull a heavier load? How could you modify this design so that your car could run for short periods in complete darkness or low light situations?

1 Answers  

---

What is thrust bearing?

1 Answers   RRB,

---

what is used to check the amount & quality of fuel in two stroke ic engine?

1 Answers   Siemens,

---

The shear modulus of most materials with respect to modulus of elasticity is less than half why?

1 Answers   DRDO, RVNL,

---

why zeroth law is call zeroth law of thermodynamic ?

4 Answers   Jindal, TATA, TTL,

---

why we open open condenser vacume early when the unit get balck?

0 Answers  

---