Different types of relay fault which phase sequence??
No Answer is Posted For this Question
Be the First to Post Answer
some practicle study shows that the reactive power at the receiving end is not equal to the reactive power at the sending end.But according to theory the reactive power is exchanged by different parts of the network – capacitors and reactors permanently, but is never consumed or produced. Then Where that reacrtive power loss occuring?is there any formula to calculate reactive power loss?
what will happen if ac power supply is given to the rotor of an alternator
Why screen of the screened cable not earthed on both the ends of cable
If rotor works in clock wise what happens
At no load the PF of an alternator -Zero -Zero Lagging -Zero leading -None of the above
What is meant by reset level of the relay?
There is any especial requirement for motor to drive through with VFD?
What is water cooled chiller plant?
What is the definition of ohms law?
7 Answers AZ Engineering, Ecil,
2. What are the parameters of EHT sub-station?
1 Answers APGenco, Blue Star, Enercon,
What is referred to the electron in the outer orbit?
if single phase is 230 v three phase is 440 v then what about two phase?and why is it so?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)