Answer / Shashank Rana

In general, a solid steel rod is usually stronger than a hollow steel pipe of the same material and cross-sectional area. However, for the same mass, a hollow steel pipe may be more economical due to its lower density.n

i want to make this calution for making a buliding but i dont know the formula for this and also how much cement concrete an sand use for this calculation,calculation is below(100ft lenths 75ftwidth and 100mm thikness)plz brife the calcution thanks

1 Answers   Sobha Developers,

---

why we provide bent up reinforcement bars at l/4 ? if it is because of diagonal shear , how does it acts ?

1 Answers  

---

how to convert udl into point load??

1 Answers  

---

Deshuttering time for slab 6.15 meter

2 Answers  

---

Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M hight 3.75 meter 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks

0 Answers  

---

what is the size of 50 kg cement bag ? gunny & paper

10 Answers   NTPC,

---

rate analysis for cement pointing 1:4 , for 100 sq m

1 Answers  

---

which is the cheapest type of temporary flooring(say for using 6 months on)?

1 Answers  

---

What is Leastcount of 1. Total station 2. Theodolite 3. Dumpy level 4. Plane Table

3 Answers  

---

list out various type of codes:-

3 Answers  

---

Need advice for steel in kg for RCC Slab qty 35.64m3 and Beam/ column qty 35.39m3

1 Answers  

---

how can we calculate the cutting length of 10,12,16,20 and so on iron bars for 45 digree and 90 digree bents plz tell me if there is any formula or tabel to find it

14 Answers   Anukampa Group, AZ Engineering, L&T, Navayuga,

---