Answer / jahanavi

"Electrical Engineering" covers the full gamut of the entire science,
and has the most diverse focus selection available. It always has.

Electronics is a mere area of electrical engineering. Always has been.

There is no such thing as an "Electronic Engineer".

Answer / tejaswini

In electrical we define it as motion of electrons in charged
particles whereas in electronics its the motion of charged
particles in both metals n semiconductors n aslo in
vaccum..also electrical voltage n current r very high in KV,
As but in electonical they r very less may b in few volts n
mA....frequency on electrical is abt 50HZs/60HZs..in
electonical its in KHZs,MHz,GHz(high)......

Answer / sivaganesh

electrical means current flow in conducter
electronics means current flow in semiconducter

Answer / chintada nagendra

elctronices deals low voltage mean 6 to 12 v and currents
in the milliampere ie and electrical is nothing high
voltages and totally it is provide high gain by connecting
succeding stages any cofiguration amp in possibel only in
electronics and interegrated circuits (ICS) work only in
low voltage but not higer voltages and error corrections
very easily in out volatge due to low voltage

Answer / alamgir hossain.apece,cu.

I think,"electrical" means handling high power,low
frequency,ac system which deals with high volume power
production &driving power devices and components etc & on
the other hand,"electronics" means low power,high
frequency,semiconductor based dc system used for controlling
& devising intelligent system......ok?

Answer / iranagouda,maruti

Electrical system always deals with low frequency high power
supplighy.Eectronic system always deals with high frequence
low power supply. Electrical use fundamental all
purpuse-electricanics use based on electrical.

Answer / ranadhive

ELECTRICAL WORKS ON AC SUPPLY
WHILE ELECTRONICS WORKS ON DC SUPPLY

Answer / prem arya

Electrical is a coal based like fan iron etc and Electronic is not a coal based it is a semiconductor likes computer ...

Answer / sunny

ELETRICAL MEANS DISSCUSS ABOUT THE LARGE INSTRUMENTS LIKE
GENERATORS AND TRASFORMORS,WHERE AS ELECTONICS IS DISSCUSS
ABOUT SMALL EQUIPMENT LIKE BULB,TVETC

Answer / rahul dhingra

electronics is the application of electrical

In Siemens S7-300 PLC, what is funtion and funtion block ? What is the difference between them ? When to use function and when to use function block

2 Answers  

Whether the vacuum contactor requires Short circuit protection?If No,why?

0 Answers   Reliance,

Why do we use 36KV LAS for 33kv line and 9KV LAS for 11KV line?

1 Answers  

Waht is Inductor?

2 Answers  

During a temperature rise test of a bus duct, it is fed with 415 volts at 2000 amperes. Why dont we get an electric shock if we touch the bus bars?

7 Answers   ABB, SDBL,

In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?

0 Answers  

what will be the energy loss =? Voltage drop = ? Conductor resistance at 20 degree C = ? Temprature convertion Factor at 50 degree c = ? on ACSR DOG Condutor at following data. distance = 4.8 kM Load = 2980 kWh Size of Conductor = 6/ 0.186 Volt = 11 kV.

1 Answers   Pakistan Atomic Energy Commission PAEC,

What will happen if i connect the delta winding motor to star input.

1 Answers  

Which cable is use for rtcc control panel

0 Answers  

How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?

0 Answers  

how do you select the ct/pt rating in substation

1 Answers   Apollo, Shreem Electric Ltd, Tata Motors,

IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?

0 Answers