Why auxiliary transformers are not connected in parallel in primary stations?
No Answer is Posted For this Question
Be the First to Post Answer
why the current leads voltage in the case of a capasitor
why we step up voltage for reducing the loss, even if voltage and current are proportional anr resistance remains same
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
Why HT motor of 3.3 kw or 6.6 KV, one side foundation ( mostly non drive end ) keep insulated from ground ?
why conductors of low tensile strength 1)produce greater sag and 2)can not be used for larger spans
what is the difference between directional & non directional earth fault with example please explain.
what is corona ?
What is an Automatic Voltage Regultor & what is its use? What are the general componets we use to design an Automatic Voltage Regulator..What are the factors to be considered for its design?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
what happens if we connect two parallel ideal voltage sources across resistor?what is current flowing through resistor?
in india are trains run by DC or AC? if DC , from where it receives negative potential? because pentograph receives singe potential only?
How to check VFD outgoing voltage
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)