Why the power factor improvement is so important in industrial loads
No Answer is Posted For this Question
Be the First to Post Answer
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why we oil in tranformer/
how many BUSBAR is in electrical system?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
In a closed circuit if two 5volt power supplier are connected in parrel what is the current direction in tihs circuit?
hi i wonder will the speed of a 50hz AC motor reduce if i supply it with 25hz?
What is the calculating formula for HT and LT amps in a transformer.
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
What is the function of pulse transformer?
when will cause the negative sequence falut in electrical system?