I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

---

WHY WE CAN GENERATE POWER IN 3PHASE MODE ONLY NOT IN 4 OR 5 PHASE?

10 Answers  

---

How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend

0 Answers  

---

What is the Total Power generation Capacity in India at present ??

20 Answers   Bhel, College School Exams Tests, IBM, NTPC,

---

What is pi controller?

0 Answers  

---

In a 11kv/433v transformer,at the LT side ie 433 V side why do we need to put 3.5 core Cable upto Panel.The full load rated Amps is 666 at LV side.What value of current will flow through the Nuetral Conductor.Why can't we use 4Core Cable instea of that?

2 Answers  

---

will a bulb glow connected to two phases of a delta connection?

6 Answers  

---

What is the method of estamating of cable, CB,MCB ?

0 Answers  

---

plz tell me the potential difference between phase and netrul

2 Answers   CGL,

---

1. Why a DC motor starter is called 3 point starter

21 Answers   ABB, CG, College School Exams Tests, Crompton Greaves, Infosys, Siva,

---

What is the difference when selecting a cable between AC and DC current?

13 Answers   ABB,

---

how choose conductor&depending upon load

0 Answers   Ford, HCL,

---