Answer / vyas pratik

is normally of the RING type, through the centre of which is passed CABLE that forms the primary winding. An earth fault relay, connected to the secondary winding, is energised only when there is residual current in the primary system.

The advantage in using this method of earth fault protection lies in the fact that only one CT core is used in place of three phase CT’s whose secondary windings are residually connected. In this way the CT magnetising current at relay operation is reduced by approximately three-to-one, an IMPORTANT consideration in sensitive earth fault relays where a low effective setting is required. The number of secondary turns does not need to be related to the cable rated current because no secondary current would flow under normal balanced conditions.

What kind of battries are generaly used with Disel Generator?

1 Answers   Exide,

---

difference between a four point starter and three point starter

9 Answers  

---

In generation,transmission and distribution voltage frequency is either 50HZ or 60 HZ;why are only these frequencies?

2 Answers  

---

Type of motor stater detail and working detail

0 Answers  

---

Define step response?

0 Answers  

---

How to take Vector group test of Transformer?

16 Answers   Sunflag Steel, Zuari Cements,

---

voltage at generation stage is usually- ? a.11kv b.33kv c.66kv d.220kv

12 Answers  

---

If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)

0 Answers   TATA,

---

in 3phase 50kva dg what is the full load current for single phase laod

6 Answers  

---

Compare jfet’s and mosfet’s.

0 Answers  

---

what is bus post insulator and its applications in substations

1 Answers  

---

how df/dt relay operates & how it works?

1 Answers  

---