How to calculate the size of cables (all minium/copper) for a particular load
Answer / b janardhana rao
Normally in alluminium 1 sqmm we consider 1 amp, In copper we consider 1.5 Amps. And also its depends on wire of Insulation. Amps withstand the insulation. Isulation is good we can put it more Amps. So its depends on insulation of the cable.
Is This Answer Correct ? | 2 Yes | 3 No |
why is efficiency of transformer more than that of other rotating machines?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
how much insulation resistance 11kv & 33kv under ground cable between earth to phase & phase to phase.
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
if step down transformer step down the voltage,will current will also be proportional step up. If yes then how transformer handle such a large current?
Mention what are the types of semi-conductors?
what are the possible reaons & remedies if resistance of NGR getting heat up
Please give me a ansver for why currant transforme noe point should erthing
why single phase induction motors are not self staring ? how can we start the 1-phase Induction motor ?
How to calculate ht side cable of 630 kva oil cooled outdoor transformer?
what is dry and wet frequency withstand voltage? why & where it is used??
Why can we connect the mobile charger both ways?