Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

why there is no short circuit when any resistance is used between phase and neutral?

3 Answers  

---

what is the difference between E.L.C.B & R.C.C.B?

2 Answers  

---

How to conduct Magnetic Balance Test, Measurement of Excitation Current (both on HV- and LV-side) and vector group on a 1000 KVA distribution transformer. There is a neutral on HV side.

1 Answers  

---

what is the highest transmission voltage in India till now?

36 Answers   Bhel, Electrical,

---

What is Long rod insulator and it's applications..? merits over the disc insulator ..?

0 Answers  

---

what is the difference between electrical degree n mechanical degree?

3 Answers   IGCAR,

---

what is the potential difference between line and earth?

11 Answers  

---

Why we use 2core cable for Dc motor.Can I use 3core?

5 Answers   JK Paper, Maharaja Whiteline,

---

do we use links in a dc circuit?if so what s its use in it?

0 Answers  

---

Differentiate between real and apparent power?

0 Answers  

---

how do i commission a distribution transformer knowing all its ratings and transformation ratios?d

1 Answers  

---