If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available

If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available in the construction site but the beam has to cast in an emergency. Which dia of bar is to be used for for that situation? (If greater than 16 dia bar is not available at site)

Question Posted / m10061994

2 Answers
4219 Views
Shreeji Associates, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available in the constructio..

Answer / kalyanqaqc@gmail.com

12 mm dia bars may be used and no of bar to be adopted after calculating area of steel required as per drawing.

Is This Answer Correct ?

1 Yes

0 No

If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available in the constructio..

Answer / m10061994

2 no bar of 10 mm dia hysd bar can be used

Is This Answer Correct ?

0 Yes

5 No

Post New Answer

More Civil Engineering Interview Questions

I s code of steel

6 Answers Cicon Engineers,

WHICH KIND OF ADDITIONAL PILE DRIVEN TO INCREASE THE CAPACITY OF SUPPORTING LOADS ON VERTICAL PILES

3 Answers

Why camber is provided?

2 Answers G R InfraProjects, Tata Steel Limited,

What are the tests on concrete?

1 Answers

What are the causes of building collapse?

0 Answers

What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?

0 Answers

How many bages of cement used in 1cft?and how we calculat sand and agregats

5 Answers

what is the difference between pumpable concrete and non pumpable concrete

4 Answers

Plz tell how to find out stell bend correction for all angle of bend and in where it is? Plz answer

1 Answers

Required concret Surface Temperature prior to coating of epoxy pain with references ASTM or ACI whatever

0 Answers

hi , can anybody help me about the following doubt...... what is the difference between clear cover, cover and nominal cover to reinforcement ?

3 Answers

A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx

0 Answers

For more Civil Engineering Interview Questions Click Here