1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

What is stepper motor?

0 Answers  

---

What is transient Phenomenon?

0 Answers  

---

Is there any decided or standard frequency to check the meager testing of transformer, DG set, LT Panel in the industries in a year. I means how many times we should be check the same.

2 Answers  

---

what is the purpose of using filters in a protective relaying scheme?

0 Answers  

---

How to select a cable size for particular load?

0 Answers   Amit Enterprises, Takasago Engineering, Techno Electric and Engineering,

---

hi, could someone help me to find a control design for syncronising panel .

0 Answers  

---

If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a campus site?

2 Answers  

---

what is inrush current in transformer?

17 Answers   Bhel, Essar, GMR,

---

what is interpose vt where it is used and y it is used?

0 Answers  

---

what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?

0 Answers  

---

For 1 KVA load how much KVARH capacitor can be used ?

3 Answers   NLC, TNEB Tamil Nadu Electricity Board,

---