Answer / nadim shaikh

Bar bending schedule needs manual entry or MS Excel as follows in rows
1. sr. no
2. identification (name of member)
3. shape
4. cutting length (as per required by drawing and RCC consultant
5. total cutting length
6. numbers of members (if identical)
7. Dia of bar
8. per running meter weight of the bar multiplied by total running length
9. 8th point will give total weight of that particular member
10. remarks if any by client or consultant

how to determine H- zone in a column? where it will occur?

0 Answers  

---

I Want To Know Quantity of Cement Conc. & Sand in Column of 9"x9"x10'

0 Answers   Ajai Builders, Malhotra Associates,

---

what is idealized curve for concrere and steel

0 Answers   CSIL,

---

How can explode a block?

0 Answers  

---

3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.

0 Answers  

---

What are the types of test used to determine soil bearing capacity

5 Answers  

---

we have a bore well 275 depth & water is deliver at distance of 1000 feet from the borewell here iam not include the distance of depth and the deliver water horizontally at our reserviour tank on ground level

0 Answers  

---

What is Fly Ash & Admixture & What is the purpose of mixing Fly Ash & Admixture to Design Mix? Tell the name of commonly used Admixtures

2 Answers   LCC,

---

How is rate analysis prepared for M 25 grade of concrete?

4 Answers  

---

How to calculate laplength for 3 floors

0 Answers  

---

Difference between pre-tensioning and post-tensioning.

0 Answers  

---

If 40 backlogs are cleared m finally with 65 percent marks . Am I eligible to get visa to US

0 Answers  

---