in 33kv/11kv stepdown t/f why should we use Star point

Question Posted / jithendra

2 Answers
3503 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in 33kv/11kv stepdown t/f why should we use Star point..

Answer / .edmk

Since, 11kv voltage can be distributed for industries,hospitals and some schools, it is easier if we hav star connected secondary.
Since,in star connection we can distribute a phase line with the neutral.
Hope i cleared your doubt

Is This Answer Correct ?

3 Yes

0 No

in 33kv/11kv stepdown t/f why should we use Star point..

Answer / prajesh gajjar

whenever distribution line is concerned, we have to used delta/star transformer to fullfill the requirement of customer .

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is different between DOL(Direct on line starter), VSD, S/S(Soft starter), and A/T(Auto Transformer)

2 Answers

i want to syncronise 5 nos of DG. How? pls reply

3 Answers

How to maintain ac plant?

0 Answers HCL,

Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......

4 Answers Hindustan Unilever Limited,

What is meant by full pitched winding?

0 Answers

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers

How to calculate voltage drop loss in HT 11000 Volts XLPE Aluminium conductor cable. Any specific formula or Thumb rule

2 Answers

Operation carried out in thermal power stations?

0 Answers

what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .

0 Answers

We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......

0 Answers MSEB,

How to calculate & connection of 900KVA generator 2 sets & load(1500A)? How to choose cable size and ACB size for this load & generator? please explain me detail. Regards, Mr.Han

3 Answers Powermec, TATA,

We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?

0 Answers

For more Electrical Engineering Interview Questions Click Here