Can Anyone Answer anyone of these ?
Q1) why direct SOLUTION of Load Flow Studies in Not Possile ?
Q2)Why majority of Buses in power system are load buses
Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ?
Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
No Answer is Posted For this Question
Be the First to Post Answer
What are protections for dty type transformers
CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE IT AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND TAKING OUTPUT FROM PRIMARY?
WHEN TWO ALTERNATORS ARE OPERATING IN PARALLEL, EXPLAIN WHY IT IS OBJECTIONABLE TO OPERATE ONE AT A LEADING POWER FACTOR AND ONE AT THE Lagging power factor?
What is the voltage violating limit to be considered for load flow study? What is acceptable deviation limit according to relevant standards?
What is meant by system?
how much Hp motor is required for water suction pump in home uses ?
what is the difference between 11kv and 13.8 kv? why we can't used one of these 2 sources?
i have a wire.and the current flowing in that.when we cut the wire then why dont we seen the elactrons....
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Why HT cable have only 3 core ?
What are all present producing cost of Per KWH of various Fuel?
how do you select the ct/pt rating in substation
1 Answers Apollo, Shreem Electric Ltd, Tata Motors,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)