Why shunt Generator is not recommended to start at ON LOAD condition???
Answers were Sorted based on User's Feedback
Answer / nitin khatana
because it does n't build up full voltage and we don't want that consumer get directly 3v to 230v, by this the equipment get damaged.
Is This Answer Correct ? | 0 Yes | 1 No |
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Why charcoal and salt add in earthing pit.
6 Answers Garware, NTPC, Sterling Wilson,
what is the d/f b/w iverter & converter.
Is MEN and RCD related to each other ?? IF yes then how??
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
Why using synchronising methed in DG's sets?
Reason of secondary of ct always short
what is the potential difference between line and earth?
What is nyquist contour?
Dear all,recently in our plant we installed a conveyor for this the motor ratings are 5 hp and Amps 7.39.Due to on urgent starting of conveyor we fix the DOL starter with range of 9-15 amps.give me suggestion regarding on this issue
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
what s a servo motor? how to control the servo motor? and its application, purpose of using?