If I installed wrong directions orifice plate then what showing
value d.p transmitter?
Answers were Sorted based on User's Feedback
Answer / carl_ellis
Various published papers (from USA's Nuclear Regulatory
Commission to Gas Technology Institute) agree that an
orifice plate installed backwards reads low anywhere from
8-25% below the actual true flow rate.
Furthermore, under-measurement error is reasonably well
correlated by the orifice "Beta ratio".
Carl Ellis
Measure First
Is This Answer Correct ? | 4 Yes | 1 No |
What is the main difference between the terms instrumentation and Automation?
suppose, after calibrating a transmitter we fixed it in a process line. At live zero condition the Tx shows 4.5 mA. what should we do to make the Tx show 4 mA? If we adjust zero, will it not affect the calibration?
Why shield is not connected at both end.
what5 does intrinsically safe mean.
what is the difference between -24 : +24 & 0:24 and where it use?
in transmiters(rose mount) how to check output 4-20ma ? and input 24v? i need exact explanation?
WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
55 Answers ABB, Adani, Adani Power, GMR, IIUC,
what are turbo generators?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Can anybody tell me the exact explanation for Functional calibration?When it should be done on process or on lab? Advanced Thanks
Witch type cable use for rtd ,why?
Explain ratio control system.