Interested to Buy Any Domain ? << Click Here >> for more details...
If I installed wrong directions orifice plate then what showing
value d.p transmitter?
- 2 Answers
- 7598 Views
- Forbes, STS, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
Various published papers (from USA's Nuclear Regulatory
Commission to Gas Technology Institute) agree that an
orifice plate installed backwards reads low anywhere from
8-25% below the actual true flow rate.
Furthermore, under-measurement error is reasonably well
correlated by the orifice "Beta ratio".
Carl Ellis
Measure First
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Tr. Wiring for calibration.
Explain the difference between mmwc and mmwg?
What is the purpose of bypass valve across AS valve.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
which type inter lock use in petrochemical refinery,and oil & gas?
Reason for capillary type dp level transmitter fluctuation
What is the start up procedure of desalter
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
Square root calculation for dp flow transmitter?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Calibration procedure for Electro magnetic Flow meter
Exothermic reaction./ endothermic reaction
How to change dcs card in online. (Dsc is maxdna)
how to measure draft pressure in transmitter pl. give its single line digram
What are the interlocks we have to check during the start up of LP/HP compressor?
