Answer / nmv

Emergency shut down

if i change range of flow transmitter in th field then does it need to change range in dcs?

3 Answers  

---

What is the difference between antisurge

1 Answers  

---

how to use one 4-20mA signal for two indicater or controller & give necessary precaution.

2 Answers  

---

HELLO FRENDS ,, I M IN THE MIDST OF TROUBLE .. JUST LITTLE HELP ME... SUPPOSE ,, I HAVE A CLOSE VESSELE TANK ( HEXANE MEDIA ) ,, I M USING ROSEMOUNT 2051 DPT FOR LEVEL APPLICATION .. ITS CALIBRATE RANGE IS.. . 0 TO 950 MMH20 ..I DID CALIBRATED DPT WITHOUT REMOVING IMPULSE LINE OF HIGH AND LOW TAPPING.. & WITHOUT DISTURB 3 WAY MANIFOLD..!!! BUT ,,, DURING CALIBRATION I SELECT RANGE BY HART LRV IS 900 MMH20 & URV IS 1300 MMH20 ,, BUT ,TANK LEVEL SOMETIMES 100 % AT 1100 MMH20 , SOMETIMES 1300 MMH20 ..IN THIS CONDITION .. WHOLE LOOP FAILED ,, MAIN THING IS THAT ,, HOW TO CUSTOME RANGE SELECT ?? AND IF I USED RANGE OVER THE ORIGINAL CALIBRATE RANGE ,,,THEN WHAT ERROR WILL BE COME ??? HOW TO ZERO CALIBRATION OF DPT... HOW TO ZERO TRIM BY MANIFOLD ?? AND FOR TANK LEVEL PURPOSE ... WHICH UNIT I CAN USE ??? IS THERE ANY CALCULATION OR CALIBRATION .. IF YEH .. THEN PLZ JUST GIVE ME CALIBRATION STEPS FOR DPT.. THANKS YOURSSSSSSS

1 Answers   Torrent Pharma,

---

what is Instrument Schedule, and what it is mainly used for?

0 Answers  

---

In turbine, what does term CDP, NI, NH, HSSOC, means

0 Answers   ADMA OPCO,

---

Why Pressure Transmitter is NOT installed before up-stream of an ORIFICE PLATE? in a flow measurement.

4 Answers   Mecon,

---

When LP SURGE happening in compressor

3 Answers   KNPC, KOC,

---

HOW TO CALIBRATE A DRUM LEVEL TRANSMITTER

2 Answers  

---

how to explain PID?

2 Answers   Jindal,

---

what is ILD

1 Answers  

---

define feed forward control loop with example and drawing?

0 Answers   Honeywell,

---