Answer / faiyaz ahmad

interface level transmitter working on the Archimedes principle the loss of weight of body immersed in liquid is equal to amount of weight of liquid displaced by the body

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on display 4 only few second.... But can we get output without using getch and also output will hold on the display...?

1 Answers  

---

how u calibate pr tx without master tx?

2 Answers  

---

What is stripper & spilitter ? Diffrence in this.?

0 Answers   JSW,

---

what is difference between accelerometer vibration sensor and proximity vibration sensor

3 Answers  

---

what is difference between hart signal and analog signal (4 to 20 ma)

2 Answers   Takreer,

---

How much flow is passing through 6 inch line? There are no gauge, no any transmitters in line.

3 Answers  

---

What is Process portal A(PPA)?

1 Answers   ABB,

---

hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?

0 Answers  

---

We have yokogawa cs3000 one fcs and 4 his. After download to his, showing successfully at es, but not transferred to his.

1 Answers   Shyam Steel,

---

defination of plc

14 Answers   ABC, Sofcon,

---

what is mapping in instrumentation and control engineering

2 Answers  

---